环氧地坪施工进程中的8种不好防止的题目

宣布日期:2018-06-27 阅读次数:129

在咱们氧的进程中,施工的时辰常常会碰到一些题目,影响着咱们施工中的一些结果,对一些罕见的施工题目,能够会致使结果降落。我给大师列出一些在施工傍边罕见的八种环境,这些环境能够会由于一些小的任务会对结果发生一些差别的影响。今后在氧的进程中请注重上面八大罕见题目,能够会由于一些微缺乏道的大任务影响了全体的结果,若是另有甚么题目请接洽咱们山东。咱们在线为您交换解答您的迷惑。以下几种在施工中呈现的题目都是由于施工不妥构成的。今后咱们只需在施工傍边注重一下,防止呈现以下几种题目。

In the process of our oxygen floor construction, we often encounter some problems, which affect some of the effects of our construction. For some common construction problems, the effect may be reduced. I'll give you a list of eight common situations in construction, which may have different effects because of some small things. Later in the process of oxygen flooring, please pay attention to the above eight common problems, which can affect the overall effect because of some trivial things. If there are any other problems, please contact us Shandong epoxy flooring. We will communicate online to answer your questions. The following problems in construction are caused by improper construction. In the future, we only need to pay attention to the construction to avoid the following problems. 

一、漆面比拟粗糙

1. Coarse finish

新上漆的外表粗糙,凡是是所用的漆刷不洁净环氧树脂漆 或受四周环境净化构成的。也有能够是油漆中混有漆皮,在操纵前未经积淀和过滤,或油漆未干时沾上了尘埃。为防止发生上述题目,必须接纳洁净的漆刷和漆桶。旧漆操纵前,必然要用滤纸或洁净的尼龙丝袜过滤。别的,漆好的外表在油漆未干时要用罩子或硬纸板遮住,以防沾上尘埃。若是漆面粗糙,待其干透后,用干湿两用砂纸打磨滑腻、擦净后,再从头刷上油漆。要出格注重漆刷必须是洁净的。

The newly painted surface is rough, usually because the brush used does not clean epoxy paint or is caused by environmental pollution. It may also be that the paint is mixed with paint, which has not been precipitated and filtered before use, or is covered with dust when the paint is not dry. To prevent these problems, clean brushes and buckets must be used. Before using the old paint, it must be filtered with filter paper or clean nylon stockings. In addition, the painted surface should be covered with a cover or cardboard when the paint is not dry to prevent dust. If the surface of the paint is rough, after it is dried out, polish it smooth with wet and dry sandpaper, then brush it again. Special attention should be paid to the fact that the paint brushes must be clean.

二、油漆起泡

2. Paint blistering

起首,用尖物把泡刺破,若是有水冒出来,即申明漆层底下或面前有潮气渗透,经太阳一晒,水份蒸发成蒸气,就会把漆皮顶起成泡。此时,先用热风喷枪撤除起泡的油漆,让木材天然枯燥,而后刷上底漆,最后再在全数修补面上从头上漆。若泡中无水,就可以够是木纹开裂,内有少许氛围,经太阳一晒,氛围收缩,漆皮就兴起了。面临这类环境,先刮掉起泡的漆皮,再用树脂填料填平裂纹,从头上漆,或不必填料,在刮去漆皮后,间接涂上微孔漆。

First, puncture the bubbles with a sharp object. If water comes out, it means that there is moisture under the paint or behind it. When the water evaporates into vapor after sunshine, it will bubbles the top of the paint. At this time, first remove the foaming paint with hot air spray gun, let the wood dry naturally, then brush the primer, and finally re-paint the entire repair surface. If there is no water in the bubbles, it may be wood grain cracking, with a small amount of air in it. When the sun shines, the air expands and the paint bulges. Faced with this situation, first scrape off the foaming paint, then fill the cracks with resin filler, re-paint, or no filler, after scraping off the paint, directly coat with micro-porous paint.

三、油漆呈现剥落

3. Peeling of paint

能够是物体外表过于滑腻的缘由。若原涂料是有光漆或是粉质的(加未经处置的色浆涂料),新上的油漆在外表就粘不牢。或能够是木材陈旧迂腐或金属有锈斑,也有因油漆品质不好而剥落的。小面积的油漆剥落,可先用细砂纸打磨,而后抹上腻子,刷上底漆,再从头上漆。大面积的剥落必须把漆全数刮去,从头涂刷。

It may be that the surface of the object is too smooth. If the original paint is glossy or powdery (with untreated paste paint), the new paint will not stick well on the surface. or it could be wood decay or rust stains on metals, or peeling off because of poor paint quality. Small areas of paint peeling, you can first use fine sandpaper polishing, then put on putty, brush primer, and then re-paint. A large area of peeling must be scraped off and re-painted.

四、上了漆不光芒

4. Painting without luster

不上底漆或底漆及内层漆还没干就间接上有光漆城市致使不光芒的环境。其次有光漆的品质不好也是一个缘由。处置方式是用干湿两用砂纸把旧漆磨掉,刷去打磨的尘埃,用洁净湿布把外表擦净,待干透后,再从头刷上面漆。另有一点要出格注重的是,在气温很低的环境下涂漆,漆膜干后也能够会落空光芒。

The absence of primer or primer and direct varnish before the inner paint is dry can lead to a lack of luster. Secondly, the poor quality of varnish is also a reason. The solution is to use wet and dry sandpaper to rub off the old paint, brush off the polished dust, wipe off the surface with a clean wet cloth, and then brush the paint again after drying out. It is also important to pay special attention to the fact that the film may lose its luster after drying when it is painted in a very low temperature environment.

五、油漆发生污斑

5. Spot on Paint

油漆外表发生污斑的缘由良多。比方墙上的物资被乳胶漆中的水份熔解而锈出漆面构成污斑,用钢丝绒掠过的墙面会发生锈斑,墙内暗管渗漏也会呈现污斑等等。为了防止呈现污斑,可先刷一层含铝粉的底漆,若已呈现污斑,能够先撤除污斑处的乳胶漆,刷层含铝粉的底漆后,再从头上漆。

There are many reasons for the stain on the paint surface. For example, the material on the wall is dissolved by the water in the latex paint and rust out of the paint surface to form stains, the wall surface wiped with steel wool will produce rust stains, and the leakage of hidden pipes in the wall will also appear stains and so on. In order to prevent stains, you can first brush a layer of primer containing aluminium powder, if stains have occurred, you can first remove the latex paint stains, brush the primer containing aluminium powder, and then re-paint.

六、漆面呈现裂纹

6. Cracks on the Paint Surface

这类环境也属于比拟罕见的,处置起来也比拟轻易,若是地坪涂料裂纹的面积比拟大的话,咱们大大都是操纵化学除漆剂或热风喷枪将裂纹地区撤除以后,再从头上漆。若是裂纹规模不是很大,那末用砂磨块或干湿两用砂纸沾一点水,磨去断裂的油漆,垂垂打磨滑腻以后,抹上腻子,再刷上底漆,从头上漆。

This situation is also relatively common and easy to handle. If the crack area of floor paint is relatively large, most of us use chemical paint remover or hot air spray gun to remove the crack area, and then re-paint. If the crack range is not very large, then use sand block or dry-wet sandpaper to dip a little water, grind the broken paint, slowly polish the smooth, put on putty, then brush the primer, re-paint.

七、油漆过了好久都不干

7. The paint has not been dry for a long time.

油漆不干,那必定是跟室内透风或温度有干系了,透风不好或温度较低会令油漆就干得慢。以是你要做的便是翻开局部门窗增进透风,或你也能够在室内放一个加热器增添室内温度。若是还不能处置题目,则有能够是上漆的外表过于清淡。这时辰能够用上面说起的化学除漆剂或加热法撤除油漆,完整把外表擦洁净,而后再从头上漆。

Paint does not work, it must be related to indoor ventilation or temperature, poor ventilation or low temperature will make the paint dry slowly. So all you have to do is open some doors and windows to promote ventilation, or you can put a heater in the room to increase the indoor temperature. If it can't solve the problem, it may be that the painted surface is too greasy. At this time, the chemical paint remover mentioned above or heating method can be used to remove the paint, thoroughly clean the surface, and then re-paint.

八、漆面不谨慎黏上了小植物

8. Small animals accidentally adhered to the lacquer surface

常常碰到如许的环境,刚上了漆的工具很轻易就粘上了虫子蚊子之类的小植物,这时辰要尽快把他们剔去,由于油漆还没干,修补就比拟轻易,只需用刷子沾一点油漆悄悄抹一下就可以规复。如果油漆已差未几干了,那末就要比及漆膜完整变硬再把小虫擦掉了,如许做才不不至于把滑腻的外表弄得一塌胡涂。

辛劳清算!转载请说明来自 http://elsmithint.com/show.asp?id=149
在线征询
微信征询
接洽德律风
137-7148-9633
前往顶部